NOTE: To use an MicroSD card
system, ensure that the
Internal SD Card Port is enabled in System Setup.
NOTE: If reinstalling, ensure that you install the
MicroSD cards into the same slots based on the labels you had marked
on the cards during removal.
Locate the MicroSD card connector on the IDSDM/vFlash module.
Orient the MicroSD card appropriately and insert the contact-pin end
of the card into the slot. To locate IDSDM/vFlash,
System board jumpers and connectors section.
NOTE: The slot is keyed to ensure correct insertion of the card.
Press the card into the card slot to lock it into place.