Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell EMC PowerEdge R640 Installation and Service Manual

PDF

Installing the VGA module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the front bezel.
  4. Remove the backplane cover.
  5. Remove the air shroud.
    NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route these cables properly when you replace them to prevent them from being pinched or crimped.

Steps

  1. Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
  2. Align the hole on the module with the screw hole on the system.
  3. Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
    Figure 1. Installing the VGA module
    This image shows how to install the VGA module.

Next steps

  1. Route the VGA cable and connect it to the VGA connector on the system board. For locating the connector, see the System board jumpers and connecters section.
  2. Install the air shroud.
  3. Install the backplane cover.
  4. Install the front bezel.
  5. Follow the procedure listed in After working inside your system.
.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\