Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

XPS 8910 Service Manual

PDF

Procedure

CAUTION: If either the processor or the heat-sink assembly is replaced, use the thermal grease provided in the kit to make sure that thermal conductivity is achieved.
NOTE: The original thermal grease can be reused if the original processor and heat-sink assembly are reinstalled together.
  1. Connect the blower cable to the system board.
    For more information, see “System-board components”.
  2. Place the heat-sink assembly over the processor.
  3. Align the captive screws on the heat-sink assembly with the screw holes on the system board.
  4. In a non-adjacent sequence, tighten the captive screws that secure the heat-sink assembly to the system board.
  5. Place the blower over the heat-sink assembly.
  6. Align the screw holes on the blower to the screw holes on the heat-sink assembly.
  7. Replace the screws that secure the blower to the heat-sink assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\