- Notes, Cautions, and Warnings
- Before working inside your computer
- After working inside your computer
- Removing the base panel
- Replacing the base panel
- Removing the memory modules
- Replacing the memory modules
- Removing the solid-state drives
- Replacing the solid-state drives
- Removing the hard drive
- Replacing the hard drive
- Removing the wireless card
- Replacing the wireless card
- Removing the palm rest
- Replacing the palm rest
- Removing the touch pad
- Replacing the touch pad
- Removing the keyboard
- Replacing the keyboard
- Removing the power-button board
- Replacing the power-button board
- Removing the status-light board
- Replacing the status-light board
- Removing the I/O board
- Replacing the I/O board
- Removing the speakers
- Replacing the speakers
- Removing the front AlienFX LED boards
- Replacing the front AlienFX LED board
- Removing the hinge covers
- Replacing the hinge covers
- Removing the display assembly
- Replacing the display assembly
- Removing the display bezel
- Replacing the display bezel
- Removing the display panel
- Replacing the display panel
- Removing the display hinges
- Replacing the display hinges
- Removing the display back-cover
- Replacing the display back-cover
- Removing the camera
- Replacing the camera
- Removing the Alienware AlienHead LED board
- Replacing the Alienware AlienHead LED board
- Removing the display-panel AlienFX LEDs
- Replacing the display-panel AlienFX LEDs
- Removing the logo board
- Replacing the logo board
- Removing the system board
- Replacing the system board
- Removing the heat-sink assembly
- Replacing the heat-sink assembly
- Removing the fans
- Replacing the fans
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the battery
- Replacing the battery
- Removing the computer base
- Replacing the computer base
- BIOS setup program
- Flashing the BIOS
- Getting help and contacting Alienware
Alienware 15 Service Manual
Procedure
- Align the screw holes on the display hinges with the screw holes on the computer base.
- Replace the screws that secure the display hinges to the computer base.
- Route the logo-board cable through the routing guide on the display hinge.
- Connect the logo-board cable to the system board and secure it with the tape.
- Slide the display cable into the system board and press down on the latch to secure the cable.
- Route the antenna cables through the routing guide on the display hinges.
- Adhere the adhesive tape that secure the antenna cables to the system board.
- Slide the antenna cables through the slot on the computer base.
- Close the display and turn the computer over.
- Route the antenna cables through the routing guide on the computer base.
- Replace the screws that secure the display assembly to the computer base.
- Turn the computer over and open the display as far as possible.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\