- Notes, cautions, and warnings
- About your system
- Using the system setup and boot manager
- Installing and removing system components
- Troubleshooting
your system
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial I/O device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting the power supply
- Troubleshooting cooling problems
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting a hard drive
- Troubleshooting expansion cards
- Troubleshooting the processor
- Using system diagnostics
- Jumpers and connectors
- Technical specifications
- System messages
- Getting help
Dell DL1000 Appliance Owner's Manual
System profile settings screen
- Menu Item
- Description
- System Profile
- Allows you to set the system profile. If you set the System Profile option to a mode other than Custom, the BIOS automatically sets the rest of the options. You can only change the rest of the options if the mode is set to Custom. By default, the System Profile option is set to Performance Per Watt Optimized (OS).
- CPU Power Management
- Allows you to set the CPU power management. By default, the CPU Power Management option is set to System OS DBPM . DBPM is Demand-Based Power Management.
- Memory Frequency
- Allows you to set the memory frequency. By default, the Memory Frequency option is set to Maximum Performance .
- Turbo Boost
- Allows you to enable or disable the processor to operate in turbo boost mode. By default, the Turbo Boost option is set to Enabled.
- C1E
- Allows you to enable or disable the processor to switch to a minimum performance state when it is idle. By default, the C1E option is set to Enabled.
- C States
- Allows you to enable or disable the processor to operate in all available power states. By default, the C States option is set to Enabled.
- Memory Refresh Rate
- Allows you to set the memory refresh rate. By default, the Memory Refresh Rate option is set to 1x.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\