CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized
in your product documentation, or as directed by the online or telephone
service and support team. Damage due to servicing that is not authorized
by Dell is not covered by your warranty. Read and follow the safety
instructions that came with the product.
Remove the blade from the sleeve.
Rotate the mezzanine card retention latch to unlock the
mezzanine card.
NOTE: Hold the
mezzanine card by its edges only.
Lift the mezzanine card up and away from the blade system
board.
If you are permanently removing the mezzanine card, you
must install a mezzanine blank over the vacant mezzanine card slot.
To install a mezzanine blank:
Place the mezzanine blank on the mezzanine card connector. When properly seated, the tabs underneath the mezzanine blank
cover all corners of the mezzanine card connector and the tab on the
side of the mezzanine blank rests over the slot on the chassis wall.
Rotate the mezzanine card retention latch over the mezzanine
blank to secure it in position.
Install the blade in the sleeve.
Figure 1. Removing and
Installing a Mezzanine Card
mezzanine card
locking tab on the side of the mezzanine card
mezzanine card slot
mezzanine card retention latch
Figure 2. Removing and
Installing a Mezzanine Blank
tabs under the mezzanine blank (4)
mezzanine blank
locking tab on the side of the mezzanine blank
mezzanine card slot
mezzanine card retention latch
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\