NOTE: The SD card in the
lower card slot is the primary card (labeled as SD1) and the SD card
in the upper card slot is the secondary card (labeled as vFlash/SD2).
Enter the System Setup and ensure that the
Internal
SD Card Port
is enabled.
NOTE: If the
Redundancy option is set to Mirror mode in the
Integrated
Devices
screen of the system setup, you must follow the
instructions in step 5 through step 7 to avoid loss of data.
Remove the blade from the sleeve.
If the redundancy option is set to
Disabled, replace the failed SD card with a new SD card.
Replace the SD card with a new SD card.
Install the blade in the sleeve.
Enter the System Setup and ensure that the
Internal
SD Card Port
and
Redundancy mode
is enabled.
Ensure that the new SD card is functioning properly.
Figure 1. Replacing the
SD Card
SD card
SD card slot
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\