The embedded system diagnostics program is run from the
Dell Lifecycle Controller.
CAUTION: Use
the embedded system diagnostics to test only your system. Using this
program with other systems may cause invalid results or error messages.
As the system boots, press
<F11>.
Use the up and down arrow keys to select
System Utilities >
Launch Dell Diagnostics.
The
ePSA Pre-boot System Assessment window
is displayed, listing all devices detected in the system. The diagnostics
starts executing the tests on all the detected devices.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\