Allows you to enable the
COM port or
Console Redirection options.
Serial Port Address
Allows you to set the port address for serial devices. By default,
the
Serial Port Address option is set to
COM1.
NOTE: Only Serial Device 2 can be used for Serial Over LAN (SOL). To use
console redirection by SOL, configure the same port address for console
redirection and the serial device.
Failsafe Baud Rate
Displays the failsafe baud rate for console redirection. The BIOS
attempts to determine the baud rate automatically. This failsafe baud
rate is used only if the attempt fails and the value must not be changed.
By default, the
Failsafe Baud Rate option is
set to
11520.
Remote Terminal Type
Allows you to set the remote console terminal type. By default,
the
Remote Terminal Type option is set to
VT 100/VT220.
Redirection After Boot
Allows you to enable or disable to the BIOS console redirection
when the operating system is loaded. By default, the
Redirection
After Boot
option is set to
Enabled.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\