Transfer the following components to the new system board:
internal USB key
storage controller card
SD vFlash card
memory modules and memory module blanks
processor(s) and heat sink(s), or processor filler blank
CAUTION: Ensure that the system board plate is parallel with the chassis.
Slide the new system board into the open end of the blade
chassis until the retention latch engages.
When the board assembly is installed correctly, the tabs on
the system board pan snap into the corresponding openings in the floor
of the blade chassis.
Replace the mezzanine card(s) in their original locations.
Reinstall the hard-drive/SSD backplane.
Replace the hard drive(s)/SSD(s). If there are two drives, ensure that you reinstall them in their
original locations.
Reinstall the cooling shroud.
Close the blade.
Remove the plastic I/O connector covers from the back of
the blade.
Install the blade in the enclosure.
Import your new or existing iDRAC Enterprise license. For
more information, see the
iDRAC7 User's Guide, at
dell.com/support/home.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\