If you need to power up all
Storage Center hardware, turn on the
expansion
enclosures
first,
then turn on the
storage
controllers
.
Connect the
expansion
enclosures
and
storage
controllers
to a power source.
Turn on each
expansion enclosure attached
to the
Storage Center.
Simultaneously press both power switches
on the rear of the
expansion enclosure to turn on the
expansion enclosure.
The status indicator on the front of the
expansion enclosure turns blue when the
expansion enclosure is powered
up and operational
NOTE: After an
expansion enclosure is powered on, its ID number is displayed by LEDs on the back panel.
If you want the IDs for all the
expansion
enclosures
to
appear in sequential order, turn on each
expansion enclosure, one after
the other, in the order you want the ID to appear.
Repeat with each
expansion enclosure attached
to the
Storage Center, waiting for
each to become operational before turning on the next
expansion enclosure.
NOTE: Make sure that all
disks are up and running before turning on any
storage
controllers
.
After all
expansion
enclosures
are
powered on, turn on each
storage
controller
by pressing and holding the power button
on the front of the
storage
controller
. The fans turn on as an indication that the
storage
controller
is starting
to come up.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\