Post Installation
Configuration For Remote Enablement
This section details the steps to configure the dependent RPMs
if you have installed the Remote Enablement feature.
The post installation configuration script is available at /opt/dell/srvadmin/etc/ on the server file system.
After installing all the dependent RPMs and the Remote Enablement
feature, run the autoconf_cim_component.sh script.
Before running the autoconf_cim_component.sh script, ensure that Systems Management is installed.
Run the following command to configure sfcb and openwsman as per the default configurations:
./ autoconf_cim_component.sh
NOTE: To configure openwsman on the managed node to run on a different port, use
the -p <port> option with autoconf_cim_component.sh. This is optional and by default the openwsman is configured
to run on port 443.
NOTE: To successfully use openwsmand and sfcbd services on systems running the supported Linux server operating system with SELinux enabled, use the following commands: