跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Setting dot1p Priorities for Incoming Traffic

Change the priority of incoming traffic on the interface using the dot1p-priority command from INTERFACE mode. The Dell Networking OS places traffic marked with a priority in a queue based on the following table.

If you set a dot1p priority for a port-channel, all port-channel members are configured with the same value. You cannot assign a dot1p value to an individual interface in a port-channel.
Table 1. dot1p-priority Values and Queue Numbers
dot1p Queue Number
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Change the priority of incoming traffic on the interface. dot1p-priority

Example of Configuring a dot1p Priority on an Interface

  • NOTE: The dot1p-priority command marks all incoming traffic on an interface with a specified dot1p priority and maps all incoming traffic to the corresponding queue. When you enable PFC and/or ETS on an interface, incoming traffic with a specified dot1p priority can be distributed across different queues. Therefore, when you use PFC and ETS to manage data center traffic, it is not recommended that you use the dot1p-priority command to set a queue assignment. For more information, refer to Data Center Bridging (DCB) . 
Dell#config
                                 Dell(conf)#interface tengigabitethernet 1/0
                                 Dell(conf-if)#switchport
                                 Dell(conf-if)#dot1p-priority 1
                                 Dell(conf-if)#end
                                 Dell#

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\