跳至主要內容
登出

歡迎來到 Dell

我的帳戶
  • 簡單快速地下訂單
  • 檢視訂單及追蹤商品運送狀態
  • 建立並存取您的產品清單
  • 使用「公司管理」來管理您的 Dell EMC 網站、產品和產品層級連絡人。
登入 建立帳戶 Premier 登入 合作夥伴計畫登入
與我們連絡

您的 Dell.com 購物車

Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide

PDF

Configure Cluster IP Addresses and the Default Gateway

Configure the client subnet mask, optional VLAN ID, controller IP addresses, a client VIP, and default route for the first appliance. IP addresses and VIPs for additional appliances can be configured at this time or configured later by Dell Storage Manager.

Prerequisites

IP addresses must be reserved for the FluidFS cluster on the client network. See IP Addresses and Network Infrastructure .

Steps

  1. Use the following command to add a client subnet. Specify the client subnet mask, optional VLAN ID, and an IP address for each controller on this subnet. 
    CLI> environment network subnets add <Prefix_Length> [-VLANTag <VLAN ID>]  ‑PrivateIPs <IP1, IP2>
    Example: 
    environment network subnets add 16 -VLANTag 0 -PrivateIPs 198.51.100.16,198.51.100.1
  2. For IPv4, use the following command to configure the default gateway: 
    CLI> environment network default-gateway add-IPv4 [gateway_IP_address]
    For IPv6, use the following command to configure the default gateway: 
    CLI> environment network default-gateway add-IPv6 [gateway_IP_address]
  3. Add at least one client VIP in the same subnet as defined in Step 1 : CLI> client-access DNS-and-VIPs public-ips add <IP>

對此內容評分

準確
實用
易懂
這篇文章對您有用嗎？
0/3000 characters
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  請給予評分 (1 到 5 顆星)。
  本文章是否有幫助？請選擇。
  評語中不得包含下列特殊字元：<>()\