- About This Guide
- Notes, Cautions, and Warnings
- Introduction
- Deployment Prerequisites
- Install and Connect the FS8600 Hardware
- Configure the
FluidFS Cluster
- Configure FluidFS Cluster Network Settings
- Connect to the FluidFS Cluster CLI
- Configure Cluster IP Addresses and the Default Gateway
- Use Dell Storage
Manager to Configure the FluidFS Cluster
- Prerequisites
- Log In to Dell Storage Manager
- Add the FluidFS Cluster to Dell Storage Manager
- Select Appliances
- Configure the Client Network
- Configure the Default Gateway
- Configure DNS Settings
- Configure Time Settings
- Select Storage Centers
- Configure Fibre Channel SAN Connectivity
- Configure iSCSI SAN Connectivity
- Finalize FluidFS Cluster Configuration
- Remove a FluidFS Cluster From Dell Storage Manager
- Configure FluidFS Cluster Network Settings
- Perform Post-Setup Tasks
- Upgrade an Appliance to the Latest FluidFS 6.0 Version
- iSCSI Switch Configuration Examples