Prerequisites
NOTE
Ensure that your operating system supports the version of the TPM module being installed.
Ensure that you download and install the latest BIOS firmware on your system.
Ensure that the BIOS is configured to enable UEFI boot mode.
Removing the TPM:
Locate the TPM connector on the system board.
Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
Slide the TPM module out from its connector.
Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
Pull the plastic rivet out of its slot on the system board.
Installing the TPM:
To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
Press the plastic rivet until the rivet snaps into place.
Replace the screw that secures the TPM to the system board.
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet.
Power on the attached peripherals and then power on the system.
