This tutorial provides step-by-step instructions on how to remove and install the optical drive in OptiPlex Small Form Factor 7020. Before you begin, power off the computer, and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the system.
In this video we show how to replace the optical drive in an OptiPlex Small Form Factor 7020. Before you begin, turn off the computer and disconnect all the attached peripherals. Ensure that you always use ESD protection when working inside the computer.
To begin, loosen the two captive screws that secure the side cover to the chassis. Slide the cover towards the back of the computer and lift it away. Gently pry and release the bezel tabs sequentially from the top. Rotate the front bezel outwards and remove it. Now, place the computer on its side with the opening facing up. If there’s a hard drive in your computer, disconnect the two cables attached to it.
To remove the disk-drive cage, start by removing the two cables from their routing guides. Then, remove the screw securing the cage. Lift it at an angle and slide it outwards. Flip the cage over and place it on the chassis. Now, disconnect the two cables connected to the optical drive. Remove the screw that secure the drive to the disk-drive cage. Gently slide it out of the cage.
To instaal the optical drive, slide into the disk-drive cage until it snaps into place. And then, replace the screw to secure it. Connect the two cables to their connectors on the optical drive. Now, flip the disk-drive cage. Align the tabs on the cage with its slots on the chassis at a certain angle, and slide it into its slot. And lower it in to place.
Align the screw hole on the cage with that on the chassis, And replace the screw to secure it. Route the two cables through the routing guides on the cage. If there’s a hard drive in your computer, connect the two cables to the respective connectors. Place the computer in upright.
Insert the tabs on the right side of the bezel into their corresponding slots on the chassis. Rotate the left-side of the bezel towards the chassis, and press it, snapping the tabs into position. Then, align the tabs on the side cover with the slots on the chassis and slide the cover towards the front.
Finally, replace the two screws to secure the side cover. For more information or support visit Dell.com/Support.
