Home
Support Home
Support Videos
How to replace a 25 Slot Drive Disk for VNX1 and VNX2

How to replace a 25 Slot Drive Disk for VNX1 and VNX2

Published DEC 17, 2024

This Dell EMC Customer Replaceable Unit (CRU) Video demonstrates how to replace a Disk drive in a 25 Slot VNX1 or VNX2 System.

An actual faulted drive can be identified by an amber fault LED on the drive carrier. Press on the drive’s latch button to release the latch, and slowly pull the drive about one inch from its slot. Wait 30 seconds for the drive to stop spinning, and then remove it.

The part number for the drive is located here. Align the replacement drive with the guides in the slot. With the drive latch open, gently push the drive into the slot. Push the handle down to engage the latch.

Suggested Videos

How to Run the SP collect Utility and Retrieve SP collect files to collect information from a VNX Storage Processor (SP)

How to Run the SP collect Utility and Retrieve SP collect files to collect information from a VNX Storage Processor (SP)

2:25

How to fix the error : You have selected an invalid combination of LUNs.The component LUNs must be the same size and RAID type in CLARiiON and VNX

How to fix the error : You have selected an invalid combination of LUNs.The component LUNs must be the same size and RAID type in CLARiiON and VNX

3:37

How to Safely remove VNX BLOCK-CLARiiON LUN's from a VNX FILE-Celerra

How to Safely remove VNX BLOCK-CLARiiON LUN's from a VNX FILE-Celerra

5:20

How to change IP addresses for a VNX Unified system (OE for File 7.0.35 and later)

How to change IP addresses for a VNX Unified system (OE for File 7.0.35 and later)

15:43

How to Replace a VNX1 or VNX2 DPE Battery Backup Unit

How to Replace a VNX1 or VNX2 DPE Battery Backup Unit

0:48

Related Articles