Adhere to safety guidelines. Power off, disconnect, and remove the system cover. Loosen screws to remove and install the Mezzanine card securely.
Prerequisites Follow the safety guidelines listed in the Safety instructions. Power off the system and all attached peripherals. Disconnect the system from the electrical outlet and disconnect the peripherals. If applicable, remove the system from the rack. Remove the system cover.
Removing the Mezzanine card: Use the Phillips #2 screwdriver, loosen the captive screws that secure the Mezzanine card to the system. Lift the Mezzanine card out of the sled. NOTE: To prevent damage to Mezzanine card, you must hold the card only by its edges.
Installing the Mezzanine card: Align the connector on the Mezzanine card with the connector on the system board. Place the Mezzanine card on the connector and press the blue touch point firmly until it is fully seated. Using the Phillips #2 screwdriver, tighten the captive screws on the Mezzanine card.
If applicable, remove the I/O connector cover from the system connectors. Install the sled into the enclosure. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
