CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
Follow the safety guidelines listed in safety instructions section.
Keep the Phillips #2 screwdriver ready.
Follow the procedure listed in the Before working inside your system section.
Turn off the sled by using the Chassis Management Controller (CMC).
Remove the sled from the enclosure.
Install the I/O connector cover.
Removing the optional rSPI card:
Remove the two screws securing the rSPI card to the system board.
CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.
Lift the card up and away from the system.
Installing the optional rSPI card:
Align the two screw holes on the rSPI card with the standoffs on the system board.
Install the two screws to secure the rSPI card to the system board.
Follow the procedure listed in the After working inside your system section:
Install the sled in the enclosure.
Turn on the sled.
