How to enable debug for the vRealize Data Protection Extension for NetWorker

Summary: This KB article describes how to enable debug for the vRealize Data Protection Extension for NetWorker in the edp_4_vcac.log file.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

The following procedure enables debug in the edp_4_vcac.log log file:

  • The default edp_4_vcac.log level is the same as the log level set in the Control Center configure logs.
    • The max file count and max file size values provided in the Control Center are only for server.log file.
  • Increasing the edp_4_vcac.log level in the /var/lib/vco/app-server/conf/log4j.xml value takes precedence over the Control Center configure level.
  • Change the vco Priority Value to "DEBUG":
<category additivity="false" name="com.emc.edp4vcac"> <priority value="DEBUG"/> <!-- Set to whatever level you want --> </category>​​​​​​

Additional Information

Saving log parameters in Control Center log4j.xml overwrites the edp_4_vcac.log changes. It is recommended to first configure logs in the Control Center and then change log4j and restart the vco-server service for all nodes.

Affected Products

vRealize Data Protection Extension for NetWorker

Products

NetWorker, vRealize Data Protection Extension for NetWorker
Article Properties
Article Number: 000013734
Article Type: How To
Last Modified: 24 جمادى الآخرة 1447
Version:  6
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.