Dell Networking: Configuring TLV Select Organization Specific TLV on OS10

Summary: The Type-Length-Value (TLV) Select Organization TLV is a specific type of TLV used within Link Layer Discovery Protocol (LLDP) to handle vendor-specific extensions. It is part of the organizationally specific TLV defined in LLDP, which is used to carry custom information that the standard TLV does not cover. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

This feature is supported starting from firmware Version 10.6.0.1 release and is available in all subsequent releases.

Use this interface mode command to enable the transmission of the specified Service Tag and Solution ID TLV in the Power Distribution Unit (PDU).

OS10(conf-if-eth1/1/1)# lldp tlv-select org-tlv service-tag

The no form of this command disables the specified TLV.

OS10(conf-if-eth1/1/1)# no lldp tlv-select org-tlv service-tag

OS10(conf-if-eth1/1/1)# show configuration
!
interface ethernet1/1/1
 no shutdown
 switchport access vlan 1
 flowcontrol receive on
 no lldp tlv-select org-tlv service-tag

Parameters: Specify the Organization TLV.

OS10(conf-if-eth1/1/1)# lldp tlv-select org-tlv
  product-base           Enable product base tlv
  product-serial-number  Enable product serial number tlv
  product-part-number    Enable product part number tlv
  service-tag            Enable service tag tlv

It can be applied to either a single interface or multiple interfaces in interface range mode.

This command is not supported in SmartFabric mode.

Article Properties
Article Number: 000348545
Article Type: How To
Last Modified: 23 Jul 2025
Version:  1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.