Connectrix: Sådan genstarter du en Cisco MDS-switch

Summary: Sådan genstarter du en Cisco MDS-switch.

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.
Check out other resources

Instructions

For at genstarte en switch i Connectrix MDS-serien skal du køre følgende kommandoer for at gemme konfigurationen og genindlæse.

ADVARSEL: DETTE ER EN FORSTYRRENDE PROCEDURE! AL FIBRE CHANNEL-TRAFIK (FC) TABES PÅ DENNE SWITCH, MENS SWITCHEN GENINDLÆSES!
  1. Gem konfigurationen:
copy run start
  1. Vent, indtil konfigurationsgemningen er fuldført.
  2. Når konfigurationslagringen er fuldført, skal du genindlæse switchen:
reload

Affected Products

Connectrix MDS-Series Hardware

Products

Connectrix MDS-Series Firmware, Connectrix MDS-Series Hardware, Connectrix MDS-Series Software
Article Properties
Article Number: 000009881
Article Type: How To
Last Modified: 22 Sep 2022
Version:  3
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.