OptiPlex 5060 Teardown Removal Guide for Customer Replaceable Units (CRUs)
Summary: An OptiPlex 5060 teardown removal can be performed for customer replaceable units by following these instructions.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
These guides take you step by step through the safe removal of what are considered to be the Customer Replaceable Unit (CRU) parts of the various OptiPlex 5060 form factors. (CRUs are the parts of the system that should not need an engineer to remove or replace.) The guides also include figures to reference what is involved.
Table of Contents:
- Removal Guide Introduction
- The Mini Tower (MT) Chassis
- The Small Form Factor (SFF) Chassis
- The Micro Form Factor (MFF) Chassis
Cause
Not applicable
Resolution
Removal Guide Introduction
If these guides do not cover what you are looking to do, then reference your System Manual.
The Mini Tower (MT) Chassis
The Small Form Factor (SFF) Chassis
The Micro Form Factor (MFF) Chassis
- OptiPlex 5060 MFF (Micro Form Factor) Teardown removal guide for customer replaceable units (CRUs)
- OptiPlex Micro Form Factor Mounting Options and Installation Methods
| If you require further assistance, contact Technical Support. | ||
| Contact Us |
Affected Products
OptiPlex 5060 Tower, OptiPlex 5060 Micro, OptiPlex 5060 Small Form FactorArticle Properties
Article Number: 000148767
Article Type: Solution
Last Modified: 30 Jun 2023
Version: 7
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.