PowerStore:异步复制会话不同步、出现 System_Paused 状态、没有任何进展或者将会影响节点稳定性

Summary: 在最近的节点重新启动或在 NDU 期间重新启动后,PowerStore 卷复制显示为不同步。如果不解决,这种情况会影响系统稳定性。创建新的复制会话后不久可能会发生节点重新启动。

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Symptoms

系统报告复制不同步,并且系统暂停活动。

在用户界面上触发警报:
A replication session in this state cannot synchronize data from the local cluster to the remote cluster until the issue is resolved. The RPO for this session might be out of compliance.

日志或警报指示:
May 11 22:53:26.629200 ::: B_ALERT volume Major A replication session associated with resource Test-Repl2 is in System_Paused state because of error: Transit object with Handle cbcf96ea-e8c8-4d88-8024-4bc507d7ac7c:34:761 : status not available.

复制会话还尝试删除和重新创建,此后会话显示没有任何进展。
  • PowerStore 节点会由于这种情况而重新启动。

Cause

该问题与网络相关,因为最近对存储网络 MTU 所做的更改与用户的网络基础设施不一致。

在一个特定的情况下,用户将存储网络(异步复制传输层)从标准的 1500 MTU 更改为 9000。

Resolution

MTU 必须在整个用户网络中具有一致的配置。
创建不一致的 MTU 网络会破坏复制关系,并影响 PowerStore 稳定性,因为节点最终会因这种错误配置而重新启动。

将存储网络配置恢复为 MTU 1500。
这使复制可以继续工作,而无需您执行任何进一步的操作。

提醒:
虽然验证工具(PowerStore UI 中位于“Protection/Remote System”下的“Verify and Update”)可能会显示与远程站点的连接正常,但支持人员仍需要借助特定数据包大小,使用 ping 测试对从源到 DR 以及从 DR 到源进行检测,确认 MTU 9000 传输无法正常工作。

Additional Information

在另一种情况下,当源站点和远程站点上的存储网络都配置有相同的 IP 地址范围时,复制也可能会显示没有进展。这是一种罕见的情况,在初始实施期间可能会因人为错误而发生。

该问题与以下文章无关:
KB 185143:PowerStore:在 PowerStore 群集 NDU 成功后,复制会话同步进入 System_Paused 状态(英文版)。

Affected Products

PowerStore
Article Properties
Article Number: 000187268
Article Type: Solution
Last Modified: 26 Dec 2022
Version:  5
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.