OS10 Inleiding tot MTU-configuratie

Summary: Inleiding tot MTU-configuratie De maximale transmissie-eenheid (MTU) definieert de grootste pakketgrootte die een interface zonder fragmentatie kan verzenden. Een juiste MTU-configuratie is cruciaal voor netwerkprestaties en stabiliteit. Dit document bevat gedetailleerde informatie over MTU-gedrag, standaardinstellingen en configuratieopdrachten voor Dell Power Switches. ...

This article applies to This article does not apply to This article is not tied to any specific product. Not all product versions are identified in this article.

Instructions

Belangrijkste behandelde onderwerpen 

Standaard MTU-configuratie

  • De standaard MTU-waarde is 9216 bytes vanaf release 10.5.4.4. Voorheen was dat 1532 bytes.
  • Opdrachten voor het configureren en verifiëren van MTU-waarden:
    • default mtu <value>: Hiermee stelt u een aangepaste MTU-waarde in voor alle interfaces zonder dat een door de gebruiker geconfigureerde MTU
    • no default mtu: Interfaces worden gereset naar de standaard MTU-waarde van het systeem
    • show default mtu: Toont de standaard MTU op systeemniveau
    • show interface: Toont de huidige MTU voor een specifieke interface 

Voorbeelden van MTU-configuratie

  • Voorbeelden van het weergeven en wijzigen van de standaard MTU met behulp van CLI-opdrachten
  • Configuratiescenario's voor Virtual LAN's (VLAN) en virtuele netwerken, die het belang benadrukken van consistente MTU-instellingen in alle interfaces om L2 en L3 VPN-flaps te voorkomen

Overwegingen en best practices

  • Zorg voor uniforme MTU-instellingen voor alle interfaces, inclusief logische en fysieke interfaces tussen Border Gateway Protocol (BGP)-peers
  • Fragmentatie wordt niet ondersteund op de meeste Dell Power Switches, met uitzondering van op specifieke modellen zoals de S4200-ON serie en S5148-ON platforms
  • OS10 selecteert de laagste MTU-waarde die is geconfigureerd op het VLAN of VLAN-leden als de VLAN MTU

 MTU

  • Na een upgrade naar 10.5.4.4 wordt de MTU standaard ingesteld op 9216 op alle VLAN's en Ethernet-interfaces die nog geen door de gebruiker geconfigureerde MTU hebben

Mogelijke problemen met onjuiste MTU-configuratie 

Packet Loss

  • Als de MTU te laag is ingesteld, komen grotere pakketten te vervallen, wat leidt tot aanzienlijk dataverlies en verslechtering van de netwerkprestaties 

Netwerkkleppen

  • Inconsistente MTU-instellingen tussen interfaces kunnen L2 en L3 VPN-flaps veroorzaken, waardoor de stabiliteit en connectiviteit van het netwerk worden verstoord 

Verhoogde latentie

  • Onjuiste MTU-instellingen kunnen leiden tot meer fragmentatie, wat leidt tot een hogere latentie en een verminderde doorvoersnelheid

Standaard MTU-configuratie, uitleg en enkele opdrachten

Toont de standaard MTU.

OS10# show default mtu
Default MTU 9216 bytes

Systeemstandaard zonder gebruikersconfiguratie

OS10# show interface ethernet 1/1/1
Ethernet 1/1/1 is up, line protocol is down
Hardware is Eth, address is 90:b1:00:00:00:a0
 Current address is 90:b1:00:00:00:a0
Pluggable media present, QSFP+ type is QSFP+ 40GBASE-LR4
 Wavelength is 1311
 Receive power reading is no power
Interface index is 11
Internet address is not set
Mode of IPv4 Address Assignment: not set
Interface IPv6 oper status: Disabled
MTU 9216 bytes, IP MTU 1500 bytes
LineSpeed 0, Auto-Negotiation off
Flowcontrol rx off tx off
ARP type: ARPA, ARP Timeout: 60
Last clearing of "show interface" counters: 20:45:24
Queuing strategy: fifo
Input statistics:
 0 packets, 0 octets
 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
 0 Multicasts, 0 Broadcasts, 0 Unicasts
 0 runts, 0 giants, 0 throttles
 0 CRC, 0 overrun, 0 discarded
Output statistics:
 0 packets, 0 octets
 0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
 0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
 0 Multicasts, 0 Broadcasts, 0 Unicasts
 0 throttles, 0 discarded, 0 Collisions, wred drops
Rate Info(interval 30 seconds):
 Input 0 Mbits/sec, 0 packets/sec, 0% of line rate
Output 0 Mbits/sec, 0 packets/sec, 0% of line rate
Time since last interface status change: 20:45:25
OS10# configure terminal
OS10(config)# default mtu 9000
OS10(config)#

 

Standaard MTU CLI 1

  • Voorbeeld 
OS10# default mtu 9216
OS10# no default mtu
 

Standaard MTU CLI 2
 

MTU 1MTU 1 vervolg,


Tabel 54. Gebruiksscenario's van VLAN MTU-configuratie.
Configuratie
 
Ethernet-interfaceconfiguratie
Interface-uitvoer weergeven
interface vlan300 no shutdown ! interface ethernet1/1/6 no shutdown switchport mode trunk switchport trunk allowed vlan300 ! interface ethernet1/1/9 no shutdown switchport mode trunk switchport trunk allowed vlan300 OS10# show interface vlan300 Vlan300 is up, line protocol is up Address is 14:10:10:0d:00:e9, Current address is 14:10:10:0d:00:e9 Interface index is 84 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Enabled Link local IPv6 address: fe80::1010:10ff:fe0d:e9/10 MTU 1532 bytes, IP MTU 1500 bytes
interface vlan300 no shutdown ! interface ethernet1/1/6 no shutdown switchport mode trunk switchport trunk allowed vlan300 ! interface ethernet1/1/9 no shutdown switchport mode trunk switchport trunk allowed vlan300 mtu 1312   OS10# show interface vlan300 Vlan300 is up, line protocol is up Address is 14:10:10:0d:00:e9, Current address is 14:10:10:0d:00:e9 Interface index is 84 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Enabled Link local IPv6 address: fe80::1010:10ff:fe0d:e9/10 MTU 1312 bytes, IP MTU 1280 bytes
virtual-network 3333 ! interface vlan300 no shutdown virtual-network 3333 ! interface ethernet1/1/6 no shutdown switchport mode trunk switchport trunk allowed vlan300 ! interface ethernet1/1/9 no shutdown switchport mode trunk switchport trunk allowed vlan300 mtu 1312 OS10# # show interface vlan300 Vlan300 is up, line protocol is up Address is 14:18:77:0d:00:e9, Current address is 14:18:77:0d:00:e9 Interface index is 84 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Enabled Link local IPv6 address: fe80::1618:77ff:fe0d:e9/64 MTU 1532 bytes, IP MTU 1500 bytes
virtual-network 3333 ! interface vlan300 no shutdown virtual-network 3333 ! interface virtual-network 3333 interface ethernet1/1/6 no shutdown switchport mode trunk switchport trunk allowed vlan300 ! interface ethernet1/1/9 no shutdown switchport mode trunk switchport trunk allowed vlan300 mtu 1312 show interface vlan300 Vlan300 is up, line protocol is up Address is 14:18:77:0d:00:e9, Current address is 14:18:77:0d:00:e9 Interface index is 84 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Enabled Link local IPv6 address: fe80::1618:77ff:fe0d:e9/64 MTU 1532 bytes, IP MTU 1500 bytes OS10# show interface virtual-network 3333 Virtual-network 3333 is up, line protocol is up Address is 14:18:77:0d:00:ea, Current address is 14:18:77:0d:00:ea Interface index is 87 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Enabled MTU 1312 bytes, IP MTU 1280 bytes
MTU-gebruiksscenario's
  • Voorbeeld
OS10(conf-if-eth1/1/7)# mtu 3000

MTU 4

Standaard MTU 1 weergeven

  • Voorbeeld
OS10# show default mtu
Default MTU 9216 bytes
 

Standaard MTU 2 weergeven

Additional Information

Affected Products

SmartFabric OS10 Software
Article Properties
Article Number: 000228459
Article Type: How To
Last Modified: 07 Nov 2025
Version:  4
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.