PowerFlex How to set a foreign disk as BOSS-S2 native
Summary: This article explains how to convert an OS Disk from a foreign state to be used in RAID 1 in BOSS Card.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Instructions
Import and set a foreign virtual disk as BOSS-S2 native.
About this task
Steps
Enter the BOSS-S2 Configuration utility.
- Turn on the system.
- While the system is booting, press <F2> to enter System Setup.
- Click Device Settings.
Device Settings lists all the RAID controllers in the system.
-
Click Physical/Virtual disk information.
-
Click Virtual disk information.
-
Select the virtual disk.
-
Select Yes for the option Would you like to import this virtual disk?
-
Click OK, and then click Import.
-
Click Back until you return to the screen.
-
Click Finish, and then click Yes to save the settings.
NOTE: This option is only available when the controller detects a foreign disk.
Additional Information
Products
PowerFlex rack, PowerFlex custom node, PowerFlex appliance R650, PowerFlex appliance R6525, PowerFlex appliance R660, PowerFlex appliance R6625, Powerflex appliance R750, PowerFlex appliance R760, PowerFlex appliance R7625, PowerFlex custom node
, PowerFlex custom node R650, PowerFlex custom node R6525, PowerFlex custom node R660, PowerFlex custom node R6625, PowerFlex custom node R750, PowerFlex custom node R760, PowerFlex custom node R7625, PowerFlex rack connectivity, PowerFlex rack HW, PowerFlex rack RCM Software, PowerFlex Software, PowerFlex appliance R640, PowerFlex appliance R740XD, PowerFlex appliance R7525, PowerFlex appliance R840
...
Article Properties
Article Number: 000249178
Article Type: How To
Last Modified: 16 Nov 2024
Version: 1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.