Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

PDF

Establish Sessions with VLAN Neighbors

To establish a session, enable BFD at interface level on both ends of the link, as shown in the following illustration. The session parameters do not need to match.

Figure 1. Establishing Sessions with VLAN Neighbors Illustration of establishing sessions with VLAN neighbors.

To establish a BFD session with a VLAN neighbor, follow this step.

Establish sessions with a VLAN neighbor. INTERFACE VLAN mode bfd neighbor ip-address
View the established sessions using the show bfd neighbors command, as shown in the following example. 
R2(conf-if-vl-200)#bfd neighbor 2.2.3.2
                                 R2(conf-if-vl-200)#do show bfd neighbors
                                 
                                 * - Active session role
                                 Ad Dn - Admin Down
                                 C - CLI
                                 I - ISIS
                                 O - OSPF
                                 R - Static Route (RTM)
                                 V - VRRP
                                 
                                 LocalAddr RemoteAddr Interface State Rx-int Tx-int Mult Clients
                                 * 2.2.3.2 2.2.3.1    
                                 Vl 200    Up    200    200    3    C

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\