Dell EMC PowerEdge R7425 Installation and Service Manual

Removing a memory module

Prerequisites

Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Remove the air shroud.
If installed, remove the mid drive tray.

WARNING Allow the memory modules to cool after you power off the system. Handle the memory modules by the card edges and avoid touching the components or metallic contacts on the memory module.

CAUTION To ensure proper system cooling, memory module blanks must be installed in any memory socket that is not occupied. Remove memory module blanks only if you intend to install memory modules in those sockets.

NOTE You must follow the thermal restriction while using DIMM blank. For information about thermal restriction, see the Thermal restrictions section.

Steps

Locate the appropriate memory module socket.
CAUTION Handle each memory module only by the card edges, ensuring not to touch the middle of the memory module or metallic contacts.
Push the ejectors outward on both ends of the memory module socket to release the memory module from the socket.
Lift and remove the memory module from the system.
Figure 1. Removing a memory module

Next steps

Install a memory module.
If you are removing the memory module permanently, install a memory module blank. The procedure to install a memory module blank is similar to that of the memory module.

NOTE For single processor systems, install processor/DIMM blank on CPU2 socket.

欢迎

欢迎访问戴尔

Dell EMC PowerEdge R7425 Installation and Service Manual

Removing a memory module

Prerequisites

Steps

Next steps

对此内容评级