- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Disassembly and reassembly
- Subscriber Identity Module(SIM) board
- SD card—optional
- Base cover
- Battery
- SSD card–optional
- SSD frame
- Hard drive
- Coin-cell battery
- WLAN card
- WWAN card – optional
- Memory modules
- Keyboard lattice and Keyboard
- Heat sink
- System fan
- Power connector port
- Chassis frame
- LED board
- SmartCard module
- Touchpad panel
- System board
- Speaker
- Display hinge cover
- Display assembly
- Display bezel
- Display panel
- Display (eDP) cable
- Camera
- Display hinges
- Display back cover assembly
- Palm rest
- Troubleshooting
- Getting help
Latitude 5491 Service Manual
Installing the base cover
- Place the base cover to align with the screw holders on the system and press the sides of the base cover.
- Tighten the 8 (M2.0x6) captive screws to secure the base cover to the system.
- Follow the procedure in After working inside your computer.
Zadejte hodnocení (1 až 5 hvězdiček).
Zadejte hodnocení (1 až 5 hvězdiček).
Zadejte hodnocení (1 až 5 hvězdiček).
Vyberte, zda vám článek pomohl či nikoli.
Komentáře nesmí obsahovat tyto speciální znaky: <>() \