Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

NOTE: You must remove the hard drive or SSD from a hard-drive or SSD carrier to replace a faulty hard drive or SSD from a hard-drive or SSD carrier.

Follow the safety guidelines listed in safety instructions section.
Keep the Phillips #1 screwdriver ready.
Remove the 2.5-inch hard drive or SSD from the 2.5-inch hard drive or SSD carrier.

Steps

Slide the hard drive or SSD into the hard drive or SSD carrier.
Align the screw holes on the hard drive or SSD with the holes on the hard drive or SSD carrier.
CAUTION: To avoid damaging the drive or the carrier, do not overtighten the screws.
Fasten the four screws to secure the hard drive or SSD to the hard-drive or SSD carrier.
Figure 1. Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
1. screw (4)
2. hard drive or SSD
3. hard drive or SSD carrier
4. screw hole (4)

Next steps

Follow the procedure listed in the After working inside your system section.

Velkommen

Velkommen hos Dell

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier

Prerequisites

Steps

Next steps

Bedøm indholdet