Gå til hovedindhold
Log af

Velkommen hos Dell

Min konto
  • Afgiv ordrer hurtigt og nemt
  • Se ordrer og spor status for din forsendelse
  • Opret og få adgang til en liste med dine produkter
  • Administrer dine Dell EMC-websteder, -produkter og -kontaktpersoner på produktniveau ved hjælp af Company Administration (Virksomhedsadministration).
Log på Opret en konto Log på Premier Log på Partnerprogram
Kontakt os

Dine Dell.com-kurve

Dell PowerEdge M630 Systems (VRTX Enclosure) Owner's Manual

PDF

Installing the hard drive or SSD backplane

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: You must remove the hard drive or SSD backplane to replace a faulty hard drive or SSD backplane or service other components inside the system.

  1. Follow the safety guidelines listed in safety instructions section.

  2. Keep the Phillips #2 screwdriver ready.

  3. Remove the hard drive or SSD. .

  4. Remove the hard drive or SSD backplane.

Steps

  1. Align the retention screws on the hard drive or SSD backplane cable connector with the screw holes on the system board connector.
  2. Tighten the two retention screws to secure the backplane cable connector on the system board.
  3. Install the hard drive or SSD cage.
  4. Align the guides on the hard drive or SSD backplane with the guide pins on the hard drive or SSD cage.
  5. Pressing the release latches, lower the hard drive or SSD backplane into the system until it is firmly seated, and the latches engage with the chassis.
    Figure 1. Installing the 2.5-inch (x2) hard drive or SSD backplane
    This image shows a Installing the hard drive/SSD backplane
    Figure 2. Installing the 1.8-inch (x4) SSD backplane
    This image shows a Installing the hard drive/SSD backplane
    1. hard drive or SSD backplane
    2. hard drive or SSD backplane cable
    3. release latch (2)
    4. guide pin (3)
    5. retention screw on the backplane cable connector (2)
    6. connector on system board

Next steps

  1. Install the hard drives or SSDs in their original locations.

  2. Follow the procedure listed in the After working inside your system section.

Bedøm indholdet

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
0/3000 characters
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv vurderinger (1-5 stjerner).
  Angiv, om artiklen var nyttig eller ej.
  Kommentarer må ikke indeholde følgende specialtegn: <>()\