Dell Command | Configure Version 4.1.0 Command Line Interface Reference Guide

BootOrder

Valid Argument

None

Description

Displays or sets the boot order sequence, activates boot list, and enables or disables the supported devices for legacy boot list and for UEFI boot list.

When you run the bootorder option, the following information is displayed:

Device Status — The current device status. It may be enabled or disabled.
Device Number — A unique number to identify the device on the system.
Device Type — The device type.
Short Form — Short form of the device. If the system has many devices of the similar device type, the short form of the device is displayed with a < number> notation. For example, if the system has an internal Hard Disk Drive (HDD), a USB storage device, and a modular Bay HDD, the short forms will be displayed as hdd.1, hdd.2, and hdd.3 respectively.
Device Description — Description of the device.

Supported devices are:

floppy — floppy disk
usbfloppy — USB floppy disk
hdd — hard disk
cdrom — CD-ROM
usbcdrom — USB CD-ROM
pcmcia — PCMCIA device
usbdev — USB device
usbhdd — USB hard disk
embnic — embedded NIC
nic — NIC
usbzip — USB ZIP
usbdevzip — USB device ZIP
bev — BEV device

NOTE: For legacy boot list, unknown devices are displayed as hexadecimal values. For UEFI boot list, some of the devices are displayed as UEFI with a < number> notation. Change the bootorder by providing the short form of the unknown device.

NOTE: While changing the bootorder sequence, if the system is set with a setup password, specify the setup password as the -- valsetuppwd argument. If the system has a system password set and no setup password is set, specify the system password as the -- valsyspwd argument.

Willkommen

Willkommen bei Dell

Dell Command | Configure Version 4.1.0 Command Line Interface Reference Guide

BootOrder

Diesen Inhalt bewerten