Dell PowerEdge T20 Owner's Manual

Disabling A Forgotten Password

The system's software security features include a system password and a admin password. The password jumper disables any password(s) currently in use.

Open the system.
Identify the PSWD jumper on the system board.
Remove the PSWD jumper from the system board.
- NOTE: The existing passwords are not disabled (erased) until the system boots without the jumper.
Install the cover.
- NOTE: If you assign a new system and/or admin password with the PSWD jumper installed, the system disables the new password(s) the next time it boots.
Connect the system to the electrical outlet and power-on the system.
Power off the system and disconnect the power cable from the electrical outlet.
Remove the cover.
Replace the PSWD jumper on the system board.
Close the system.
Power on the system.
Go to the system setup, and assign a new system or admin password.
For information on assigning a system or admin password, see Assigning A System And Admin Password.

Willkommen

Willkommen bei Dell

Dell PowerEdge T20 Owner's Manual

Disabling A Forgotten Password

Diesen Inhalt bewerten