- About This Guide
- Notes, Cautions, and Warnings
- Introduction
- Deployment Prerequisites
- Install and Connect the FS8600 Hardware
- Configure the
FluidFS Cluster
- Configure FluidFS Cluster Network Settings
- Connect to the FluidFS Cluster CLI
- Configure Cluster IP Addresses and the Default Gateway
- Use Dell Storage
Manager to Configure the FluidFS Cluster
- Prerequisites
- Log In to Dell Storage Manager
- Add the FluidFS Cluster to Dell Storage Manager
- Select Appliances
- Configure the Client Network
- Configure the Default Gateway
- Configure DNS Settings
- Configure Time Settings
- Select Storage Centers
- Configure Fibre Channel SAN Connectivity
- Configure iSCSI SAN Connectivity
- Finalize FluidFS Cluster Configuration
- Remove a FluidFS Cluster From Dell Storage Manager
- Configure FluidFS Cluster Network Settings
- Perform Post-Setup Tasks
- Upgrade an Appliance to the Latest FluidFS 6.0 Version
- iSCSI Switch Configuration Examples
Καλώς ορίσατε
Ιστότοποι της Dell
Ιστότοποι της Dell
Καλώς ορίσατε στην Dell
Ο λογαριασμός μου
- Υποβάλετε παραγγελίες γρήγορα και εύκολα
- Δείτε τις παραγγελίες και παρακολουθήστε την κατάσταση αποστολής
- Δημιουργήστε μια λίστα με τα προϊόντα σας για να έχετε πρόσβαση σε αυτή
- Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide
Configure the External User Database (NIS_LDAP)
FluidFS clusters can authenticate client access to NFS exports with Network Information Service (NIS) or Lightweight Directory Access Protocol (LDAP).
- To skip external authentication, select None, then click Next. The Change Administrator Password page opens. See Change the Administrator Password .
- To use Network Information Service, select NIS. See Configure NIS Settings .
- To use Lightweight Directory Access Protocol, select LDAP. See Configure LDAP Settings .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\