Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell Edge Gateway 3003 Installation and Operation Manual

System Power Management

Configuring low power states: S3 and S4

Configure sleep state–S3
$ sudo systemctl suspend
Configure hibernate state–S4
$ sudo systemctl hibernate

Rebooting or power off

To reboot the system
$ sudo reboot
To power off
$ sudo poweroff

Configuring system wake-up from LAN or WLAN

  1. Enable Wake on LAN in the BIOS program. For more information on accessing the BIOS program, see Accessing BIOS settings
  2. Connect the system to a wireless network.
    $ sudo network-manager.nmcli dev wifi connect $SSID password $PSK ifname wlan0
  3. Enable Wake on LAN.
    $ sudo iw phy0 wowlan enable magic-packet
  4. Recheck the support status.
    $ sudo iw phy phy0 wowlan show
  5. Make sure wlan0 is up and running with IP address.
  6. Perform sleep.
    $ sudo systemctl sleep
    Or, perform hibernation.
    $ sudo systemctl hibernate
  7. Use another system to wake from wlan (Supported tools: wakeonlan, and etherwake).
    $ sudo wakeonlan MAC
    $ sudo etherwake MAC

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\