Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell Edge Gateway 3003 Installation and Operation Manual

PDF

Mounting the Edge Gateway using the perpendicular mount

NOTE: The perpendicular mount is designed for mounting in a DIN-rail only.
NOTE: An open space of 63.50 mm (2.50 in) around the Edge Gateway is recommended for optimal air circulation. Ensure that the environmental temperature in which the Edge Gateway is installed does not exceed the operating temperature of the Edge Gateway. For more information about the operating temperature of the Edge Gateway, see the Edge Gateway Specifications.
  1. Align the screw holes on the perpendicular-mount bracket with the screw holes on the Edge Gateway.
    Image: Align the screw holes on the perpendicular-mount bracket with the screw holes on the Edge Gateway
  2. Tighten the four M4x7 screws to secure the Edge Gateway to the perpendicular-mount bracket.
    NOTE: Torque the screws at 8±0.5 kilograms-centimeter (17.64±1.1 pounds-inch).
    Image: Tighten the four screws to secure the Edge Gateway to the perpendicular-mount bracket
  3. Align the screw holes on the DIN-rail mount bracket with the screw holes on the perpendicular-mount bracket, and tighten the two screws.
    NOTE: Torque the screws at 8±0.5 kilograms-centimeter (17.64±1.1 pounds-inch).
    Image: Align the screw holes on the DIN-rail mount bracket with the screw holes on the perpendicular-mount bracket, and tighten the two screws
  4. Place the Edge Gateway on the DIN rail at an angle and push the Edge Gateway down to compress the springs on the DIN-rail mount brackets.
    Image: Place the Edge Gateway on the DIN rail at an angle
  5. Push the Edge Gateway towards the DIN-rail to secure the lower clip of the bracket onto the DIN rail.
    Image: Push the Edge Gateway towards the DIN-rail brackets to secure the lower clip of the bracket onto the DIN rail
  6. Secure the Edge Gateway on the DIN rail.
    Image: Secure the Edge Gateway on the DIN rail

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\