- Notes, cautions, and warnings
- Overview
- System views
- Installing your Edge Gateway
- Safety and regulatory information
- Setting up your Edge Gateway
- Activating your mobile broadband service
- Mounting your Edge Gateway
- Mounting the Edge Gateway using the standard-mount bracket
- Mounting the Edge Gateway using quick-mount bracket
- Attaching the cable control bars to the standard-mount bracket
- Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket
- Mounting the Edge Gateway using the perpendicular mount
- Mounting the Edge Gateway using a VESA mount
- Setting up the ZigBee dongle
- Setting up the operating system
- Windows 10 IoT Enterprise LTSB 2016
- Ubuntu Core 16
- Overview
- Boot up and log in – Direct system configuration
- Boot up and log in – Static IP system configuration
- Updating operating system and applications
- Additional Ubuntu commands
- Ubuntu Network Manager
- Security
- Watchdog Timer (WDT)
- Cloud LED On/Off
- Global Positioning Systems (GPS)
- Snappy auto update/Autopilot
- Accessing Snappy Store/Snapweb
- Sensors
- Ignition Pin
- System Power Management
- Restoring Ubuntu Core 16
- Flashing a new OS image
- Ubuntu Server
- Overview
- Login to the Edge Gateway using Ethernet Port 1
- Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon
- Login to the Edge Gateway using Ethernet Port 2
- Ubuntu Server driver information
- Firmware management on Ubuntu Server
- Configure Watchdog Timer (WDT)
- Trusted Platform Module (TPM)
- Cloud LED On/Off
- Advanced Linux Sound Architecture (ALSA)
- Global Positioning Systems (GPS)
- Sensors
- Ignition Pin
- System Power Management
- Ubuntu Network Manager
- Restoring Ubuntu Server
- Creating the recovery USB flash drive
- Accessing and updating BIOS
- References
- Appendix
- Contacting Dell
Dell Edge Gateway 3003 Installation and Operation Manual
Firmware management on Ubuntu Server
UEFI BIOS updates for Ubuntu Server will be released online through Linux Vendor Firmware Service (LVFS)-based methods, as described at fwupd.org.
The firmware capsule update is enabled by default. The fwupgmgr command and fwupd firmware update daemon are used to update the UEFI BIOS firmware, in compliance with LVFS requirements.
NOTE:
For additional information on how to update the firmware under Linux, see en.community.dell.com/techcenter/b/techcenter/archive/2016/02/02/dell-firmware-updating-under-linux. Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\