Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell Edge Gateway 3003 Installation and Operation Manual

PDF

Mounting the Edge Gateway using quick-mount bracket

The quick-mount bracket is a combination of the standard-mount bracket and the DIN-rail bracket. It enables you to easily mount and demount the Edge Gateway.

NOTE: The mounting brackets are shipped with only those screws required for securing the mounting brackets to the Edge Gateway.
Mounting dimensions

Image: Quick-mount dimensions

Mounting instructions
  1. Place the standard-mount bracket on the wall, and using the holes above the screw holes on the bracket, mark the positions to drill the four holes.
    Image: Place the standard-mount bracket on the wall, and using the holes above the screw holes on the bracket, mark the positions to drill the four holes.
  2. Drill four holes in the wall as marked.
  3. Insert and tighten four screws (not supplied) to the wall.
    NOTE: Purchase screws that fit the diameter of the screw holes.
    Image: Insert and tighten four screws (not supplied) to the wall
  4. Align the screw holes on the standard-mount bracket with the screws on the wall, letting the bracket hang on the screws.
    Image: Align the screw holes on the standard-mount bracket with the screws on the wall, letting the standard-mount bracket hang on the screws.
  5. Tighten the screws to secure the assembly to the wall.
    Image: Tighten the screws to secure the assembly to the wall
  6. Align the screw holes on the DIN-rail bracket with the screw holes at the back of the Edge Gateway.
  7. Place the two M4x5 screws on the DIN-rail bracket and secure it to the Edge Gateway.
    Image: Placing the two screws on the DIN-rail bracket and secure it to the Edge Gateway
  8. Place the Edge Gateway on the standard mount at an angle, and then pull the Edge Gateway down to compress the springs at the top of the DIN-rail bracket.
    Image: Mount the Edge Gateway on the standard mount and secure the Edge Gateway to the standard mount by pressing the latch
  9. Push the Edge Gateway towards the DIN-rail to secure it on the standard-mount bracket.
    Image: Push the Edge Gateway towards the DIN-rail brackets to secure it on the standard-mount bracket
    NOTE: For more information about demounting the DIN-rail, see Demounting DIN rail.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\