Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell Edge Gateway 3003 Installation and Operation Manual

PDF

Activate TPM in Dell Command | Configure

Follow these steps to check TPM activation in the Dell Command | Configure application.

  1. If not set, set the BIOS password.
    # cctk --setuppwd=<new-BIOS-password>
  2. If not enabled, enable TPM. 
    # cctk --tpm=on
  3. Reboot the system.
    # systemctl reboot
  4. Activate TPM.
    # cctk --tpmactivation=activate --valsetuppwd=<Setuppwd>
  5. Reboot the system.
    # systemctl reboot
    NOTE: Do not power off the system while it is rebooting.
  6. Check whether TPM is active.
    # cctk --tpmactivation

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\