Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell Edge Gateway 3003 Installation and Operation Manual

PDF

Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket

NOTE: The DIN-rail bracket includes the screws that are required for securing the bracket to the Edge Gateway.
  1. Align the screw holes on the DIN-rail bracket with the screw holes at back of the Edge Gateway.
  2. Place the two M4x5 screws on the DIN-rail bracket and secure it to the Edge Gateway.
    Image: Align the screw holes on the DIN-rail bracket to the back of the Edge Gateway
  3. Secure the DIN-rail mounting bracket to the Edge Gateway using the two M4x5 screws provided.
    NOTE: Torque the screws at 8±0.5 kilograms-centimeter (17.64±1.1 pounds-inch) on the DIN-rail mounting bracket.
    Image: Secure the DIN-rail mounting bracket to the Edge Gateway by using two screws.
  4. Place the Edge Gateway on the DIN rail at an angle, and then pull the Edge Gateway down to compress the springs at the top of the DIN-rail mounting bracket.
  5. Push the Edge Gateway towards the DIN-rail to secure the lower clip of the bracket onto the DIN rail.
    Image: Push the Edge Gateway towards the DIN-rail brackets to secure the lower clip of the bracket onto the DIN rail
    NOTE: For more information about demounting the DIN-rail, see Demounting DIN rail.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\