Removing the system board
- Follow the procedure in Before working inside
your computer.
- Remove the:
- cover
- front bezel
- 2.5 inch hard drive assembly
- cooling shroud
- optical drive
- M.2 PCIe SSD
- heat sink assembly
- memory module
- processor
- expansion card
- SD card
- Disconnect the following cables from the system board:
- speaker [1]
- 2.5–inch drive [2]
- optical drive [3]
- data cable [4]
- Disconnect the following cables and screw from the system board:
- PSU [1]
- hard drive and optical drive caddy stand off screw [2]
- PSU [3]
- power switch [4]
- intrusion switch [5]
- To remove the I/O panel plate:
- Remove the 6 screw that secures the I/O panel [1].
- Slide and push toward the front from the computer [2].
- To remove the system board:
- Remove the 12 screws that secure the system board to the computer
- Slide and lift the system board away from the computer [2].
Data is not available for the Topic