- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- Side cover
- Front bezel
- Fan duct
- Hard-drive assembly
- 3.5 in. hard-drive assembly
- Solid-state drive
- Memory module
- SD card reader (optional)
- Processor fan and heat-sink assembly
- Processor
- Expansion card
- Graphical processing unit
- Coin-cell battery
- WLAN card
- Slim optical-drive
- Speaker
- Power button
- Power-supply unit
- Intrusion switch
- Optional I/O modules (Type C/ HDMI/VGA/DP/Serial)
- System board
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
OptiPlex 5090 Tower Service Manual
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
- Press and slide the speaker in the slot on the chassis until it snaps into place.
- Route the speaker cable through the routing guide on the chassis.
- Connect the speaker cable to the connector on the system board.
Next steps
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\