iDRAC may become unresponsive for various reasons. iSM can fully reset an unresponsive iDRAC8 or iDRAC9 controller by temporarily removing power to the iDRAC controller without affecting operating system production. This feature can only be disabled from the iSM page in iDRAC using the iDRAC interfaces.
To reset iDRAC, use the following Windows PowerShell or Linux shell command:
./Invoke-iDRACHardReset
NOTE The shell command is supported only on VMware ESXi 7.x.
In all ESXi operating systems, you can perform the iDRAC reset remotely using the following WinRM remote command:
NOTE The remote iDRAC hard reset feature only works with iDRAC8 on the PowerEdge yx3x or later servers and if logged into the operating system as an administrator.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\