Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Latitude 5540 Owner's Manual

PDF

Installing the power button

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the power board and provide a visual representation of the installation procedure.
Image: Installing the power-button board

Steps

  1. Align and place the power button on the palm-rest assembly.
  2. Replace the two (M2x2.5) screws to secure the power button to the palm-rest assembly.

Next steps

  1. Install the system board.
  2. Install the assembly-inner frame.
  3. Install the heat sink (discrete GPU) or heat sink (integrated GPU), as applicable.
  4. Install the M.2 2230 solid-state drive in Slot 2, if applicable.
  5. Install the M.2 2230 or M.2 2280 solid-state drive in Slot 1, as applicable.
  6. Install the memory modules.
  7. Install the WLAN card.
  8. Install the 4G WWAN card or 5G WWAN card, as applicable.
  9. Install the battery.
  10. Install the base cover.
  11. Install the SIM card.
  12. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\