Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Latitude 5540 Owner's Manual

Right

Image: Right view

  1. microSD-card slot

    Reads from and writes to the microSD-card.

  2. Universal audio jack

    Connect headphones or a headset (headphone and microphone combo).

  3. USB 3.2 Gen 1 port

    Connect devices such as external storage devices and printers. Provides data transfer speeds up to 5 Gbps.

  4. USB 3.2 Gen 1 port with PowerShare

    Connect devices such as external storage devices and printers.

    Provides data transfer speeds up to 5 Gbps. PowerShare enables you to charge your USB devices even when your computer is turned off.
    NOTE:If the charge on your computer’s battery is less than 10 percent, you must connect the power adapter to charge your computer, and USB devices connected to the PowerShare port.
    NOTE:If a USB device is connected to the PowerShare port before the computer is turned off or in hibernate state, you must disconnect and connect it again to enable charging.
    NOTE:Certain USB devices may not charge when the computer is turned off or in sleep state. In such cases, turn on the computer to charge the device.
  5. HDMI 2.0 port

    Connect to a TV, external display or another HDMI-in enabled device. Provides video and audio output.

  6. Network port

    Connect an Ethernet (RJ-45) cable from a router or a broadband modem for network or Internet access, with a transfer rate of 10/100/1000 Mbps.

  7. Security-cable slot (wedge-shaped)

    Connect a security cable to prevent unauthorized movement of your computer.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\