Dell Chassis Management Controller Version 1.3 for PowerEdge FX2/FX2s RACADM Command Line Reference Guide

Description

Tests the RAC’s SNMP trap alerting feature by sending a test trap from CMC to a specified destination trap listener on the network.

To use this subcommand, you must have the Test Alerts permission.

Synopsis

racadm testtrap -i <
                                                index>
                                             

Input

-i — Specifies the index of the trap configuration to be used for the test. Valid values are from 1 to 4.

Example

Commands for the cfgIpmiPet group:

• Enable the alert

  racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1 

• Set the destination e-mail IP address

  racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr -i 1 192.168.0.110

• View the current test trap settings

  racadm getconfig -g cfgIpmiPet -i <
                                                           index>
                                                        

  where < index> is a number from 1 to 4.