Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerStore Configuring Volumes

Change volume properties


  1. Under Storage, select Volumes.
  2. Click the check box next to the volume name and then click Modify.
    NOTE:You can also access the Properties panel by clicking the name of the volume to open the volume page and then clicking Actions > Properties
    The Properties slide-out panel allows you to change the volume name and description, to increase the volume size and to change the performance policy. When you modify the size of the source volume, the size of the destination volume is also modified.
    NOTE: If you want to rename a volume that is being replicated, you must pause the replication session if a session is running. You can then change the name on the source volume only. The volume name on the destination system updates when the replication session resumes.

    To change the source volume name to a name that exists on the destination system, you must first rename the volume on that destination system.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\