Dell Chassis Management Controller Version 3.10 for PowerEdge VRTX RACADM CLI Guide

chassisaction

Table 1. Chassisaction. The following table contains description, inputs, and options available in the chassisaction command.
Description	Runs a power action on the chassis or a switch. To use this subcommand, you must have the Chassis Control Administrator privilege. NOTE: For remote racadm, check the power status of the module using the `getmodinfo` command.
Synopsis	racadm chassisaction [-m < module>] < action>
Input	-m < module> — Module on which you want to carry out the action. Values are: chassis — this is the default value, if -m is not specified. switch-n, where n=1 < action> — Action that you want to run on the specified module. Values are: powerdown — (Chassis only) Turns off the chassis. powerup — (Chassis only) Turns on the chassis. powercycle — Power cycles the module. nongraceshutdown — (Chassis only) Non-gracefully turns off the chassis. reset — Performs a hard reset of the module. When < module > = switch, < action > must be powercycle or reset.
Output	None
Example	Perform a reset of switch-1: racadm chassisaction -m switch-1 reset Module power operation successful.