Dell Chassis Management Controller Version 3.10 for PowerEdge VRTX RACADM CLI Guide

ifconfig

Table 1. Details of ifconfig. The following table provides the details of ifconfig attribute:
Description	Displays the contents of the network interface table. To use this subcommand, you must have the Execute Diagnostic Commands or Configure iDRAC privilege.
Synopsis	racadm ifconfig
Example	$ racadm ifconfig eth0 Link encap:Ethernet HWaddr 00:1D:09:FF:DA:23 inet addr:10.35.155.136 Bcast:192.168.0.1 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:2550665 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:272532097 (259.9 MiB) TX bytes:0 (0.0 B)

Table 1. Details of ifconfig. The following table provides the details of ifconfig attribute:

Description

Displays the contents of the network interface table.

To use this subcommand, you must have the Execute Diagnostic Commands or Configure iDRAC privilege.

Synopsis

racadm ifconfig

Example

$ racadm ifconfig

eth0     Link encap:Ethernet  HWaddr 00:1D:09:FF:DA:23

	          inet addr:10.35.155.136  Bcast:192.168.0.1
                                                Mask:255.255.255.0

	          UP BROADCAST RUNNING MULTICAST  MTU:1500 
                                                Metric:1

	          RX packets:2550665 errors:0 dropped:0 overruns:0
                                                frame:0

	          TX packets:0 errors:0 dropped:0 overruns:0
                                                carrier:0

	          collisions:0 txqueuelen:1000

	          RX bytes:272532097 (259.9 MiB)  TX bytes:0
                                                (0.0 B)